Badger Rings 306-28, USMC DMR, 1.031, 30mm
These rings have been designed specifically for the United States Armed Forces and are currently in use world wide. In the early 1990’s Badger Ordnance identified the need for quality Tactical scope rings and mounts designed to meet the higher demands of the emerging Military and Law Enforcement tactical shooting community. Badger Scope Rings are machined from steel barstock as serialized matched pairs. This assures that both rings are identical and eliminates the damaging effects of mismatched mass produced rings. Maximized rings are designed to fit MIL STD 1913 (also called Picatinny) optical rails and are finished with Mil Spec Black Oxide. All the hardware on our rings was designed by us and is made to our specifications including the Torx® screws that hold the scope securely in the rings. MAX-50 Rings are made to the same specifications as our standard rings but are 1 INCH wide! The MAX-50’s have 60% more holding power and were designed specifically to tame the recoil of the .50 BMG Six 8-40 Torx® screws secure each scope cap to the ring. The Maximized series of Scope Rings and Rails are made to the highest tolerances in the industry. This item is not available for export outside the USA.